DIY solar combined kits, Harbor Freight, Sunforce, Barry’s Solar Power Center
Battery charging system, 8 Sunforce 15W amorphous panels, 3 Harbor Freight 15W amphorus, 2 55W Siemens. Xantrek Trace C40 Charge controller, Power Bright 1500W pure sine. 11 12V 35Amp Hr. Sealed AGM batteries. Why the copper bar???????? www.youtube.com www.powerstream.com
Most charge controllers have a blocking diode. Check specs on the charge controller.
Make sure your system is grounded. Ground – bat side. ground – side on panels.
im new to this and from the UK can you help
i have wired 10 panels together in parallel they are 3.2 Watts 18.8Volts and 170ma per panel
not sure what this means in amps
i have 2 X 110amp batteries and a 1500 watt inverter
do i need diodes and fuses or will a carger controler do the job to stop back surge
Any advice will be great
im trying to run the lighting on an extrension first
i have 5 X 5 watt bulbs and 3 X 12 watt bulbs in there
The 4 Siemens 55w use the Trace C40.
3 Harbor freight+ 4 15w Sunforce on the Sunforce 7 amp.
The other set of 4 Sunforce panels are using the 7 amp charge controller.
The C40 wires into the center of the battery bank.
The two 7 amp charge controllers are at the corners of the battery bank.
Question: So you can have separate charge controller on a multiple solar panel?
You are fan of nikola Tesla